Lamination technology
Heated roller lamination allows laminating boards from different sizes on the same production line, this to bring down the loss of raw material.
The lamination is made with 2-component glue, which allows bringing on the board low quantities of glue, this to guarantee a smooth surface after lamination.
click on the different steps to get a complete overview of our lamination-line
Boards are loaded in the system, one by one.
Thicness control is done to ensure that the right board is loaded.
Carefull cleaning and brushing of the board must clean surfaces and sides of the board, so that dust andparticles will not affect the quality of the lamination.
Heated rolls are heating up the surface of the board, and the high pressure is making the surface smoother, so that less glue is used.
The first component of the glue is applied by roller system. This product is activating the later applied second component of the glue.
UV radiation is drying the first component of the glue.
The second component of the glue is applied on the dried board. The mosture of this second component is activated by the first component, so that glue is getting active.
The lamination self is done between the heated roller, by which the paper is applied on the board.
After lamination, the boards are still linked as the paper is applied also over the gap between 2 boards. A knife is cutting this link.
After the press, the quality of the lamination is controlled continuously, checking as well the lamination itself, as the quality of the surface.
Before packing, the board is cleaned on the long edges, by taking away the paper that is hanging over the side.
At the same time, we can offer in-line cutting of the board so that 2 equal pieces can be obtained.
Stacking is done automatically, keeping in mind the wishes of the customer.
The packing station is fixing the board, so that handling and transport can be done without affecting the quality.
